If this problem comes up when moving the seat this is very likely the case. On the vcds cables, HQ means the atmega eeprom was created from byte 0x000 to 0x1FF without using another cable.The problem might be the connector, that's to be determined because it can also be a damaged wiring harness. HQ clones is not the best definition, because usualy is associated to a high quality pc board and high quality components. Original software with cloned cable : Will never work.Ĭracked software with cloned cable : Depends on the crack level and you need to use it on a computer without access to internet (ever).Ĥ : Because it's not connected to the car, and the power supply to the atmega chip is comming from the obd connector (through the 7805 regulator), the software detects only the ftdi information but doesn't get anything from the atmega.ĥ : Since the atmega is powered, now the data is transmitted to the software and, because the ftdi chip hasn't the same serial from the original cable, it will fail the verification. You can get the atmega eeprom by cracking the mcu, but that dump will be linked to the ftdi serial and it will only work with that ftdi chip (rq chips). If I get it right - the first 4 pins on Atmel used for programming have the extra "pinholes" on the board (4 holes)? Do you know if there is a standard connector that can be attached for programming? in this forum it seems the Chinese guys used the 1:1 schematics and almost the same parts.ĭo you think this is a good quality clone? I am attaching the images of the front cover and the both sides of the board.Ĭompared to the photos of the board in the genuine R.T. I have tried to install both: the VCDS version on the DVD and the official version.īy reading this topic, if I understand correctly, there is a problem with the Atmel chip firmware? Still, there are 8 versions of VCDS 16.8.3 in different languages delivered on the DVD.Ī) When I connect the interface to the notebook USB port, but still not connected to the car - the VCDS Test function says:ī) When connected to the car - the VCDS Test function says: According to the seller's words, this interface should be the 100% copy of the original interface, and therefore compatible with the official Ross-T. I have bought a newest Chinese clone, 16.8.3, and it is the first clone ever that I have problems with.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |